 |
Premium glass déco |
|
First glass déco |
|
High tech déco |
|
Non - woven |
|
Accessories |
|
|
| |
 |
 |
Vitrulan® »magnet«
is supplied in
95 cm-wide
rolls. |
|
|
 |
|
In the box, the edges
are protected by foam plastic inserts. |
|
|
|
|
| |
 |
|
Magnetic fabric should
always be rolled
coilwise, as wound
on its roll. |
 |
|
Never bend or roll magnetic
fabric in the opposite direction as it
will cause imperfections
on the visible side. |
|
|
 |
|
The lengths of fabric
should be cut to size
on a trestle table. |
|
|
 |
|
Apply a rich and
even
coat of dispersion adhesive to the wall
using a paint roller. |
|
|
|
|
| |
 |
|
Before trimming, verify
that all serial numbers are identical. Make sure the fabric is
applied by its reverse side, which is clearly marked by a coloured
line. |
|
|
 |
|
Press and smooth
the fabric to the wall to
avoid air bubbles. |
|
|
|
|
| |
 |
|
When installing a
new length of fabric, allow
it to overlap the previous length by less than 1mm. |
 |
|
Then push the new
length back until the edges form a neat butt joint. |
|
|
|
|
 |
|
Again, press and smooth
the fabric to the wall to avoid bubbles. |
|
 |
|
Allow the
fabric and adhesive to dry thoroughly. |
 |
|
|
| |
 |
|
For the first coat
of
paint, apply an even
and generous
quantity. |
|
|
|
|
|
 |
|
Allow the
fabric to dry thoroughly. |
|
|
|
| |
 |
|
For the second coat,
evenly apply a
sufficient quantity
of paint. |
|
|
|
|
|
 |
|
Allow the
fabric to dry thoroughly. |
|
|
|
| |
 |
|
Practical advice:
If the magnetic fabric is installed on part of the wall elevation
only, it should be separated from the remaining wall covering
by means of a trim strip. |
|
|
|
|
|
|
|
